Cisco Sx350

22
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 478
IGMP Proxy Commands
22.0
22.1 ip igmp-proxy
To add downstream interfaces to an IGMP proxy tree, use the ip igmp-proxy
command in Interface Configuration mode. To remove downstream from
interfaces to an IGMP proxy tree, use the no form of this command.
Syntax
ip igmp-proxy upstream-interface-id
no ip igmp-proxy
Parameters
• upstream-interface-id —Upstream Interface identifier.
Default Configuration
The protocol is disabled on the interface.
Command Mode
Interface Configuration mode
User Guidelines
Use the ip igmp-proxy command to add downstream interfaces to an IGMP proxy
tree. If the proxy tree does not exist it is created.
Use the no format of the command to remove the downstream interface. When the
last downstream interface is removed from the proxy tree it is deleted too.
Examples
Example 1. The following example adds a downstream interface to an IGMP Proxy
process with vlan 200 as its Upstream interface:
switchxxxxxx(config)# interface vlan 100