Cisco Sx350

DHCP Snooping Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 342
13
Parameters
• name —Specifies the static ARP binding list name. (Length: 1–32
characters).
Default Configuration
No static ARP binding list exists.
Command Mode
Global Configuration mode
User Guidelines
Use the ip arp inspection list assign command to assign the list to a VLAN.
Example
The following example creates the static ARP binding list ‘servers’ and enters the
ARP list configuration mode.
switchxxxxxx(config)# ip arp inspection list create servers
13.24 ip mac
Use the ip mac ARP-list Configuration mode command to create a static ARP
binding. Use the no form of this command to delete a static ARP binding.
Syntax
ip
ip-address mac mac-address
no ip ip-address mac mac-address
Parameters
• ip-address —Specifies the IP address to be entered to the list.
• mac-address —Specifies the MAC address associated with the IP address.
Default Configuration
No static ARP binding is defined.