Cisco Sx350 User Manual

Address Table Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 142
4
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers a source IPv6 address - Multicast IPv6 address
pair to the bridge table, and forbids adding the pair to gi14 on VLAN 8:
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast source 2001:0:0:0:4:4:4 group
FF00:0:0:0:4:4:4:1
switchxxxxxx(config-if)# bridge multicast forbidden source
2001:0:0:0:4:4:4:1 group FF00:0:0:0:4:4:4:1 add gi14
4.14 bridge multicast unregistered
To configure forwarding unregistered Multicast addresses, use the bridge
multicast unregistered Interface (Ethernet, Port Channel) Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
bridge multicast unregistered
{forwarding | filtering}
no bridge multicast unregistered
Parameters
• forwarding—Forwards unregistered Multicast packets.
• filtering—Filters unregistered Multicast packets.
Default Configuration
Unregistered Multicast addresses are forwarded.

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English