Cisco Sx350

SPAN and RSPAN Commands
1099 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
57
- Source: flow mirrow, policy-map: policy-map-name, class-maps:
class-map-name1, class-map-name2
The Source is a flow mirror, only attached policy-names are displayed.
• Destination—A destination of the session. The following options are
supported:
- Destination: interface-id
The Destination is an interface, regular forwarding on the interface is not
supported.
- Destination: interface-id, network
The Destination is an interface, regular forwarding on the interface is
supported.
- Destination: RSPAN VLAN vlan-id, reflector-port interface-id
The switch is the first switch in the RSPAN session, regular forwarding on
the interface is not supported.
- Destination: RSPAN VLAN vlan-id, reflector-port interface-id,
network
The switch is the first switch in the RSPAN session, regular forwarding on
the interface is supported.
57.5 show vlan remote-span
To display a list of remote Switched Port Analyzer (RSPAN) VLANs, use the show
vlan remote-span command in User EXEC mode.
Syntax
show vlan remote-span
Parameters
This command has no arguments or keywords
Default Configuration
This command has no default settings.