Cisco Sx350

DHCP Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 294
12
Example
The following example deletes the address binding 10.12.1.99 from a DHCP
server database:
switchxxxxxx# clear ip dhcp binding 10.12.1.99
12.6 client-name
To define the name of a DHCP client, use the client-name command in DHCP Pool
Host Configuration mode. To remove the client name, use the no form of this
command.
Syntax
client-name
name
no client-name
Parameters
• name —Specifies the client name, using standard ASCII characters. The
client name should not include the domain name. For example, the .name
Mars should not be specified as mars.yahoo.com. (Length: 1–32 characters).
Command Mode
DHCP Pool Host Configuration mode
Default Configuration
No client name is defined.
Example
The following example defines the string client1 as the client name.
switchxxxxxx(config-dhcp)# client-name client1