EasyManua.ls Logo

Cisco Sx350

Cisco Sx350
1323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Quality of Service (QoS) Commands
921 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
47
Syntax
show class-map [
class-map-name
]
Parameters
class-map-name—Specifies the name of the class map to be displayed. (Length:
1–32 characters)
Command Mode
Privileged EXEC mode
Example
The following example displays the class map for Class1.
switchxxxxxx(config)#
show class-map
Class Map matchAny class1
Match access-group mac
47.6 match
Use the match Class-map Configuration mode. command to bind the ACLs that
belong to the class-map being configured. Use the no form of this command to
delete the ACLs.
Syntax
match access-group
acl-name
no match access-group
acl-name
Parameters
acl-name—Specifies the MAC, IP ACL name, or IPv6 ACL name. (Length: 1–32
characters)
Default Configuration
No match criterion is supported.

Table of Contents

Related product manuals