Virtual Local Area Network (VLAN) Commands
1277 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
67
Example
The following example displays protocols-groups information.
67.23 map mac macs-group
Use the map mac macs-group VLAN Configuration mode command to map a MAC
address or range of MAC addresses to a group of MAC addresses. Use the no
form of this command to delete the mapping.
Syntax
map mac
mac-address
{
prefix-mask
|
host} macs-group
group
no map mac
mac-address
{
prefix-mask |
host}
Parameters
•
mac-address
—Specifies the MAC address to be mapped to the group of
MAC addresses.
•
prefix-mask
—Specifies the number of ones in the mask.
• host—Specifies that the mask is comprised of all 1s.
•
group
—Specifies the group number (range: 1–2147483647)
Default Configuration
N/A
Command Mode
VLAN Database Configuration mode
switchxxxxxx#
show vlan protocols-groups
Encapsulation
-------------
Ethernet
Ethernet
Ethernet
Ethernet
Protocol
--------------
0x800 (IP)
0x806 (ARP)
0x86dd (IPv6)
0x8898
Group ID
--------
1
1
2
3
To Next Page
Loading...
