EasyManuals Logo

Cisco Sx350 User Manual

Cisco Sx350
1323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #900 background imageLoading...
Page #900 background image
Power over Ethernet (PoE) Commands
899 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
45
This force command overrides any port mode or port limit configuration.
Example
The following example force the spare pair in port 4.
switchxxxxxx(config)#
interface
gi1
4
switchxxxxxx(config-if)#
power inline four-pair forced
45.11 powered device forced
To configure the powered device to match a PSE not using protocol based
negotiation, use the powered device forced Interface Configuration mode
command.
Syntax
powered device forced {60watts | 802.3AF | 802.3AT}
no powered device forced
Parameters
Default Configuration
The default configuration is set to no powered device forced.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
This command should only be used for ports that are connected to devices that do
not support the CDP/LLDP protocol or the new 4-wire power via MDI TLV.
The command is used to force the powered device to identify powered received
from PSE, this allows the usage of 60 Watts PoE without the usage of negotiation
protocol.
CDP/LLDP will reflect power requested and power consumption of 60W.
Use the no command to return to dynamic detection (hardware or protocol based)
of PSE uplink ports.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Sx350 and is the answer not in the manual?

Cisco Sx350 Specifications

General IconGeneral
BrandCisco
ModelSx350
CategorySwitch
LanguageEnglish

Related product manuals