Cisco Sx350

PHY Diagnostics Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 888
44
44.3 show cable-diagnostics cable-length
To display the estimated copper cable length attached to all ports or to a specific
port, use the show cable-diagnostics cable-length Privileged EXEC mode
command.
Syntax
show cable-diagnostics cable-length
[interface interface-id ]
Parameters
• interface-id—(Optional) Specify an Ethernet port ID.
Command Mode
Privileged EXEC mode
User Guidelines
The port must be active and working at 100 M or 1000 M.
Example
The following example displays the estimated copper cable length attached to all
ports.
gi1 3
Test has not been performed
gi1 4
Open 64 13:32:00 23 July 2010
switchxxxxxx#
show cable-diagnostics cable-length
Port
----
gi11
gi12
gi13
Length [meters]
-----------------
< 50
Copper not active
110-140