IPv6 First Hop Security
705 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
29
Example
The following example gives an example of the show ipv6 nd snooping command
output:
switchxxxxxx#
show ipv6 nd snooping
IPv6 ND Inspection is enabled on VLANs:1-4,6,7,100-120
unsecure drop: enabled
sec-level minimum value: 2
source mac validation: disabled
29.73 show ipv6 nd inspection policy
To display an IPv6 ND Inspection policy on all ports configured with the ND
Inspection feature, use the show ipv6 nd inspection policy command in privileged
EXEC mode.
Syntax
show ipv6 nd inspection policy [
policy-name
| active]
Parameters
•
policy-name
—Displays the ND Inspection policy with the given name.
• active—Displays the attached ND Inspection policies.
Command Mode
Privileged EXEC mode
Examples
Example 1—The following example displays the policy configuration for a policy
named policy1:
switchxxxxxx#
show ipv6 nd inspection policy policy1
ND Inspection Policy: policy1
device-role: router
drop-unsecure: enabled
To Next Page
Loading...
Need help?
General
