Cisco Sx350

IPv6 First Hop Security
645 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
29
switchxxxxxx(config-nd-inspection)# exit
Example 3. The following example removes an attached ND Inspection policy:
switchxxxxxx(config)# no ipv6 nd inspection policy policy1
Policy policy1 is applied on the following ports:
gi11, gi12
The policy1 will be detached and removed, are you sure [Y/N]Y
29.28 ipv6 nd inspection sec-level minimum
To globally specify the minimum security level value, use the ipv6 nd inspection
sec-level minimum command in Global Configuration mode. To return to the
default, use the no form of this command.
Syntax
ipv6 nd inspection sec-level minimum
value
no ipv6 nd inspection sec-level minimum
Parameters
• value —Sets the minimum security level. Range: 0–7.
Default Configuration
All messages are bridged.
Command Mode
Global Configuration mode
User Guidelines
This command specifies the minimum security level parameter value when the
drop-unsecured feature is configured.
This command has no effect if dropping of non secure messages is disabled.