Cisco Sx350

Ethernet Configuration Commands
397 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
17
Default Configuration
Automatic re-activation is disabled, except for link-flap reason where automatic
re-creation is enabled by default.
Command Mode
Global Configuration mode
Example
The following example enables automatic re-activation of an interface after all
states.
switchxxxxxx(config)# errdisable recovery cause all
17.17 errdisable recovery interval
To set the error recovery timeout intervalse the errdisable recovery interval Global
Configuration mode command. To return to the default configuration, use the no
form of this command.
Syntax
errdisable recovery interval
seconds
no errdisable recovery interval
Parameters
seconds—Specifies the error recovery timeout interval in seconds. (Range: 30–
86400)
Default Configuration
The default error recovery timeout interval is 300 seconds.
Command Mode
Global Configuration mode