Cisco Sx350

MLD Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 830
40
Command Mode
User EXEC mode
User Guidelines
Use the show ipv6 mld counters command to check if the expected number of
MLD protocol messages have been received and sent.
If you omit the optional
interface-id argument, the show ipv6 mld counters
command displays counters of all interfaces.
Example
The following example displays the MLD protocol messages received and sent:
switchxxxxxx# show ipv6 mld counters vlan 100
VLAN 100
Elapsed time since counters cleared:00:00:21
Failed received Joins: 0
Total MLDv1 received messages: 10
Total MLDv2 received messages: 0
Total invalid received messages: 0
General Sent Queries: 0
Specific Sent Queries: 0
40.9 show ipv6 mld groups
To display the multicast groups that are directly connected to the router and that
were learned through Multicast Listener Discovery (MLD), use the show ipv6 mld
groups command in User EXEC mode.
Syntax
show ipv6 mld groups [link-local |
group-name | group-address | interface-id ]
[detail]