Cisco Sx350

Green Ethernet
463 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
20
When the interface is set to enhanced mode, after the VCT length check has
completed and set the power to low, an active monitoring for errors is done
continuously. In the case of errors crossing a certain threshold, the PHY will be
reverted to long reach.
Note that EEE cannot be enabled if the Short-Reach mode is enabled.
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# green-ethernet short-reach
20.5 green-ethernet power-meter reset
Use the green-ethernet power meter reset Privileged EXEC mode command to
reset the power save meter.
Syntax
green-ethernet power-meter reset
Parameters
This command has no arguments or keywords.
Default Configuration
None
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# green-ethernet power-meter reset
20.6 show green-ethernet
To display green-ethernet configuration and information, use the show
green-ethernet Privileged EXEC mode command.