Cisco Sx350

Spanning-Tree Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1136
58
58.30 show spanning-tree bpdu
Use the show spanning-tree bpdu User EXEC mode command to display the
BPDU handling when spanning-tree is disabled.
Syntax
show spanning-tree bpdu
[interface-id | detailed ]
Parameters
• interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
• detailed—Displays information for non-present ports in addition to present
ports.
IST Master ID Priority
Address
Path Cost
Rem hops
32768
00:02:4b:19:7a:00
10000
19
Bridge ID Priority
Address
32768
00:02:4b:29:7a:00
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Max hops 20
switchxxxxxx# show spanning-tree
Spanning tree enabled mode MSTP
Default port cost method: long
###### MST 0 Vlans Mapped: 1-9
CST Root ID Priority
Address
32768
00:01:42:97:e0:00
This switch is root for CST and IST master.
Root Port
gi1 1
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Max hops 20