Cisco Sx350

Address Table Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 162
4
4.29 show bridge multicast address-table
static
To display the statically-configured Multicast addresses, use the show bridge
multicast address-table static Privileged EXEC mode command.
Syntax
show bridge multicast address-table static [vlan
vlan-id ] [all]
show bridge multicast address-table static [vlan vlan-id ] [address
mac-multicast-address
] [mac| ip]
show bridge multicast address-table static [vlan
vlan-id ] [address
ipv4-multicast-address
] [source ipv4-source-address ]
show bridge multicast address-table static [vlan
vlan-id ] [address
ipv6-multicast-address
] [source ipv6-source-address ]
Parameters
• vlan vlan-id —(Optional) Specifies the VLAN ID.
• address—(Optional) Specifies the Multicast address. The possible values
are:
- mac-multicast-address—(Optional) Specifies the MAC Multicast
address.
- ipv4-multicast-address—(Optional) Specifies the IPv4 Multicast
address.
- ipv6-multicast-address—(Optional) Specifies the IPv6 Multicast
address.
• source—(Optional) Specifies the source address. The possible values are:
- ipv4-address—(Optional) Specifies the source IPv4 address.
- ipv6-address—(Optional) Specifies the source IPv6 address.
Default Configuration
When all/mac/ip is not specified, all entries (MAC and IP) will be displayed.
Command Mode
Privileged EXEC mode