Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 780
36
Example
The following example sets the interval for sending LLDP updates to 60 seconds.
switchxxxxxx(config)# lldp timer 60
36.21 lldp transmit
To enable transmitting LLDP on an interface. use the no form of this command to
stop transmitting LLDP on an interface, use the lldp transmit Interface (Ethernet)
Configuration mode command.
Syntax
lldp transmit
no lldp transmit
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Interface (Ethernet) Configuration mode
switchxxxxxx(config-if)#
User Guidelines
LLDP manages LAG ports individually. LLDP sends separate advertisements on
each port in a LAG.
LLDP operation on a port is not dependent on the STP state of a port. I.e. LLDP
frames are sent on blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx(config)# interface gi11