Cisco Sx350

System Management Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1202
62
Temperature(C): 37
62.19 show system power-supply
To view the power-supply status, use the show system power-supply EXEC mode
command.
Syntax
show system power-supply
Parameters
This command has no arguments or keywords.
Default Usage
None
Command Mode
User EXEC mode
User Guidelines
Power supply supported:
• Main (internal power supply).
• PD (POE Powered Device port).
Main Power supply statuses:
• Active - power supply is used.
• Failure - Main power has failed.
When the power supply changes to Main power supply, the following syslog
message is created: Power supply source changed to Main Power Supply.
PD
Power supply statuses:
• Active - power supply is used.