Cisco Sx350

IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 568
28
Default Configuration
The “managed address configuration flag” flag is not set in IPv6 router
advertisements.
Command Mode
Interface Configuration mode
User Guidelines
Setting the Managed Address Configuration flag in IPv6 router advertisements
indicates to attached hosts whether they should use stateful autoconfiguration to
obtain addresses. If this flag is set, the attached hosts should use stateful
autoconfiguration to obtain addresses, and if it is not set, the attached hosts
should not use stateful autoconfiguration to obtain addresses.
Hosts may use stateful and stateless address autoconfiguration simultaneously.
Example
The following example configures the Managed Address Configuration flag in IPv6
router advertisements on VLAN 1:
switchxxxxxx(config)# interface vlan 1
switchxxxxxx(config-if)# ipv6 nd managed-config-flag
switchxxxxxx(config-if)#
exit
28.16 ipv6 nd ns-interval
Use the ipv6 nd ns-interval command in Interface Configuration mode to configure
the interval between IPv6 neighbor solicitation retransmissions on an interface.
To restore the default interval, use the no form of this command.
Syntax
ipv6 nd ns-interval
milliseconds
no ipv6 nd ns-interval