Cisco Sx350 User Manual

Address Table Commands
167 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
Port Status Learning Action Maximum Trap Frequency
------- -------- --------- ------ --- ------- --------
gi11 Enabled Max- Discard 3 Enabled 100
Addresses
gi12 Disabled Max- - 28 - -
Addresses
gi13 Enabled Lock Discard 8 Disabled -
The following table describes the fields shown above.
4.33 show ports security addresses
To display the current dynamic addresses in locked ports, use the show ports
security addresses Privileged EXEC mode command.
Syntax
show ports security addresses [
interface-id | detailed]
Parameters
• interface-id —(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Field Description
Port The port number.
Status The port security status. The possible values are:
Enabled or Disabled.
Action The action taken on violation.
Maximum The maximum number of addresses that can be
associated on this port in the Max-Addresses mode.
Trap The status of SNMP traps. The possible values are:
Enable or Disable.
Frequency The minimum time interval between consecutive
traps.

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English