Cisco Sx350

IPv6 First Hop Security
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 712
29
Attached to ports:
Example 3—The following example displays the user defined policies:
switchxxxxxx# show ipv6 neighbor binding policy
policy1
policy2
29.78 show ipv6 neighbor binding prefix table
To display contents of the Neighbor Prefix table, use the show ipv6 neighbor
binding prefix table command in Privilege EXEC configuration mode.
Syntax
show ipv6 neighbor binding prefix table [vlan
vlan-id ]
Parameters
• vlan vlan-id —Displays the prefixes that match the specified VLAN.
Command Mode
Privileged EXEC mode
User Guidelines
This command displays the Neighbor Prefix table. The display output can be
limited to the specified VLAN. If no VLAN is configured, all prefixes are displayed.
Example
The following example displays the learned prefixes:
Policy Name
policy1
port-default
Ports
gi11-4
gi11-4
VLANs
1-100
101-4094