Cisco Sx350 User Manual

Loopback Detection Commands
801 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
37
Syntax
loopback-detection interval
seconds
no loopback-detection interval
Parameters
seconds—Specifies the time interval in seconds between LBD packets. (Range:
10–60 seconds)
Default Configuration
The default time interval between LBD packets is
30 seconds.
Command Mode
Global Configuration mode
Example
The following example sets the time interval between LBD packets
to 45 seconds.
switchxxxxxx(config)# loopback-detection interval 45
37.4 show loopback-detection
To display information about Loopback Detection, use the show
loopback-detection Privileged EXEC mode command.
Syntax
show loopback-detection [
interface-id | detailed]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or Port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports. If this is not set, the default is to display all present ports.
Default Configuration
All ports are displayed. If detailed is not used, only present ports are displayed.

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English