Cisco Sx350

Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 952
47
• queue-id—Specifies the queue number to which the DSCP values are
mapped.
Default Configuration
The default map for 8 queues is as follows.
Command Mode
Global Configuration mode
Example
The following example maps DSCP values 33, 40 and 41 to queue 1.
switchxxxxxx(config)# qos map dscp-queue 33 40 41 to 1
47.29 qos trust (Global)
Use the qos trust Global Configuration mode command to configure the system to
the basic mode and trust state. Use the no form of this command to return to the
default configuration.
Syntax
qos trust {cos | dscp}
no qos trust
Parameters
• cos— Specifies that ingress packets are classified with packet CoS values.
Untagged packets are classified with the default port CoS value.
• dscp—Specifies that ingress packets are classified with packet DSCP
values.
DSCP
value
0 1-8 9-15 16,24,
40,48-
63
17-23 25-31 33-39 32,
41-47
Queue-I
D
21 37 45 6 8