EasyManua.ls Logo

Cisco Sx350

Cisco Sx350
1323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rate Limit and Storm Control Commands
1003 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
50
Syntax
rate-limit
committed-rate-kbps
[burst
committed-burst-bytes
]
no rate-limit
Parameters
committed-rate-kbps
—Specifies the maximum number of kilobits per
second of ingress traffic on a port. The range is 3–maximal port speed.
burst
committed-burst-bytes
—(Optional) The burst size in bytes. (Range:
3000–19173960). If unspecified, defaults to 128K.
Default Configuration
Rate limiting is disabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
The Rate Limit does not calculate traffic controlled by Storm control. The real
allowed rate will be sum of the rate specified by the command and the rates
specified by the Storm control commands for particular traffic types.
Example
The following example limits the incoming traffic rate on gi11 to 150,000 kbps.
switchxxxxxx(config)#
interface gi11
switchxxxxxx(config-if)#
rate-limit 150000
50.3 rate-limit vlan
To limit the incoming traffic rate for a VLAN in, use the rate-limit vlan command in
Global Configuration mode. To disable the rate limit, use the no form of this
command.

Table of Contents

Related product manuals