Cisco Sx350

CDP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 218
8
Example
switchxxxxxx(config)# cdp source-interface gi11
8.13 cdp timer
To specify how often CDP packets are transmitted, use the cdp timer command in
Global Configuration mode. To return to default, use the no form of this command.
Syntax
cdp timer
seconds
no cdp timer
Parameters
seconds—Value of the Transmission Timer in seconds. Range: 5-254 seconds.
Default Configuration
60 seconds.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# cdp timer 100
8.14 clear cdp counters
To reset the CDP traffic counters to 0, use the clear cdp counters command in
Privileged EXEC mode.
Syntax
clear cdp counters [global |
interface-id ]