Cisco Sx350

Address Table Commands
151 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
Parameters
seconds —Time is number of seconds. (Range:10-500)
Default Configuration
300
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# mac address-table aging-time 600
4.22 port security
To enable port security learning mode on an interface, use the port security
Interface (Ethernet, Port Channel) Configuration mode command. To disable port
security learning mode on an interface, use the no form of this command.
Syntax
port security [forward
| discard | discard - shutdown] [trap seconds ]
no port security
Parameters
• forward—(Optional) Forwards packets with unlearned source addresses,
but does not learn the address.
• discard—(Optional) Discards packets with unlearned source addresses.
• discard-shutdown—(Optional) Discards packets with unlearned source
addresses and shuts down the port.
• trap seconds —(Optional) Sends SNMP traps and specifies the minimum
time interval in seconds between consecutive traps. (Range: 1–1000000)
Default Configuration
The feature is disabled by default.
The default mode is discard.