Cisco Sx350

Network Management Protocol (SNMP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 870
43
switchxxxxxx(config)# snmp-server user tom acbd v2c
switchxxxxxx(config)# snmp-server user tom acbd v3
43.11 show snmp users
To display the configured SNMP users, use the show snmp users Privileged EXEC
mode command.
Syntax
show snmp users [
username ]
Parameters
username—(Optional) Specifies the user name. (Length: 1–30 characters)
Default Configuration
Display all users.
Command Mode
Privileged EXEC mode
Example
The following examples displays the configured SNMP users:
switchxxxxxx# show snmp users
User name :u1rem
Group name :group1
Authentication Algorithm : None
Privacy Algorithm : None
Remote :11223344556677
Auth Password :
Priv Password :
User name : qqq
Group name : www