Cisco Sx350

Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 962
47
• dp—Specifies the drop precedence. The available values are: high, low.
Default Configuration
Set 1: All interfaces, all queues, high DP.
Set 2: All interfaces, all queues, low DP.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
If the queue parameter is all, traffic in cascading ports is also counted.
Example
The following example enables QoS statistics for output queues for counter set 1.
switchxxxxxx(config)# qos statistics queues 1 all all all
47.39 show qos statistics
Use the show qos statistics Privileged EXEC mode command to display Quality of
Service statistical information.
Syntax
show qos statistics
Parameters
N/A
Default Configuration
N/A
Command Mode
Privileged EXEC mode