Cisco Sx350 User Manual

30
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 720
IPv6 IPM Router Commands
30.0
30.1 ipv6 multicast-routing
To enable IPv6 Multicast routing on all IPv6-enabled interfaces of the router and to
enable Multicast forwarding, use the ipv6 multicast-routing command in global
configuration mode. To stop Multicast routing and forwarding, use the no form of
this command.
Syntax
ipv6 multicast-routing mld-proxy
no ipv6 multicast-routing
Parameters
• mld-proxy—Enable Multicast routing using MLD Proxy.
Default Configuration
Multicast routing is not enabled.
Command Mode
Global Configuration mode
User Guidelines
Use the ipv6 multicast-routing command with parameter to specify the needed
IPv6 Multicast Routing Protocol.
To forward IPv6 Multicast packets on an interface, IPv6 Multicast forwarding must
be enabled globally and an IPMv6 Routing protocol must be enabled on the
interface.
Example
The following example enables IPv6 Multicast routing using MLD Proxy:

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English