Cisco Sx350 User Manual

Address Table Commands
145 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
• port-channel port-channel-list —Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
Ports are not forbidden to dynamically join Multicast groups.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use this command to forbid a port to dynamically join (by IGMP, for example) a
Multicast group.
The port can still be a Multicast router port.
Example
The following example forbids forwarding of all Multicast packets to gi11 within
VLAN 2.
switchxxxxxx(config)# interface vlan 2
switchxxxxxx(config-if)# bridge multicast forbidden forward-all add ethernet
gi1 1
4.17 bridge unicast unknown
To enable egress filtering of Unicast packets where the destination MAC address
is unknown to the device, use the bridge unicast unknown Interface (Ethernet, Port
Channel) Configuration mode command. To restore the default configuration, use
the no form of this command.
Syntax
bridge unicast unknown {filtering | forwarding}
no bridge unicast unknown

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English