Cisco Sx350

IP Addressing Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 508
24
24.5 show ip interface
Use the show ip interface EXEC mode command to display the usability status of
configured IP interfaces.
Syntax
show ip interface [i
nterface-id ]
Parameters
• interface-id —Specifies an interface ID on which IP addresses are defined.
Default Configuration
All IP addresses.
Command Mode
User EXEC mode
Examples
Example 1 - The following example displays all configured IP addresses and their
types:
switchxxxxxx# show ip interface
!source_precedence_is_supported &&
!broadcast_address_configuration_is_supported && ip_redirects_is_supported
IP Address I/F I/F Status Type Directed Redirect Status
admin/oper Broadcast
------------- ------ ----------- ------- -------- --------- -----
10.5.230.232/24 vlan 1 UP/UP Static disable Enabled Valid
10.5.234.202/24 vlan 4 UP/DOWN Static disable Disabled Valid
Example 2 - The following example displays the IP addresses configured on the
given L2 interfaces and their types: