EasyManuals Logo

Cisco Sx350 User Manual

Cisco Sx350
1323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #654 background imageLoading...
Page #654 background image
IPv6 First Hop Security
653 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
29
switchxxxxxx(config)#
ipv6 nd raguard hop-limit minimum
3
maximum
100
29.34 ipv6 nd raguard managed-config-flag
To globally enable verification of the advertised the Managed Address
Configuration flag in RA messages, use the ipv6 nd raguard managed-config-flag
command in Global Configuration mode. To return to the default, use the no form of
this command.
Syntax
ipv6 nd raguard managed-config-flag {on | off}
no ipv6 nd raguard managed-config-flag
Parameters
• on—The value of the flag must be 1.
• off—The value of the flag must be 0.
Default Configuration
Verification is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command enables verification of the advertised the Managed Address
Configuration flag (or the M flag) in an RA message (see RFC4861). This flag could
be set by an attacker to force hosts to obtain addresses through a DHCPv6 server
that might not be trustworthy.
Example
The following example enables M flag verification that checks if the value of the
flag is 0:
switchxxxxxx(config)#
ipv6 nd raguard managed-config-flag
off

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Sx350 and is the answer not in the manual?

Cisco Sx350 Specifications

General IconGeneral
BrandCisco
ModelSx350
CategorySwitch
LanguageEnglish

Related product manuals