Cisco Sx350

IPv6 First Hop Security
631 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
29
switchxxxxxx(config-if)# exit
Example 2—The following example enables IPv6 First Hop Security on VLANs
100-107:
switchxxxxxx(config)# interface range vlan 100-107
switchxxxxxx(config-if-range)#
ipv6 first hop security
switchxxxxxx(config-if-range)# exit
29.19 ipv6 first hop security attach-policy
(port mode)
To attach an IPv6 First Hop Security policy to a specific port, use the ipv6 first hop
security attach-policy command in Interface Configuration mode. To return to the
default, use the no form of this command.
Syntax
ipv6 first hop security attach-policy
policy-name [vlan vlan-list ]
no ipv6 first hop security attach-policy [
policy-name ]
Parameters
• policy-name —The IPv6 First Hop Security policy name (up to 32
characters).
• vlan vlan-list —Specifies that the IPv6 First Hop Security policy is to be
attached to the VLAN(s) in
vlan-list . If the vlan keyword is not configured, the
policy is applied to all VLANs on the device on which IPv6 First Hop
Security is enabled.
Default Configuration
The IPv6 First Hop Security default policy is applied.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode