Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 412
17
Command Mode
Privileged EXEC mode
Example
The following example clears the monitored statistics for gi11.
switchxxxxxx#
clear switchport monitor gi11
17.29 show switchport monitor
To display the monitored statistics gathered by a specific interface, use the show
switchport monitor Privileged EXEC mode command.
Syntax
show switchport monitor
interface-id
{seconds | minutes | hours }
[utilization | tx | rx |
frames]
show switchport monitor
interface-id
{
days |weeks
}
show switchport monitor utilization
[interface-id]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• seconds— last 20 samples, sampled every 15 seconds.
• minutes —last 60 samples, sampled every 60 seconds (every round minute
according to system time).
• hours —last 24 samples, sampled every 60 minutes (every round hour
according to system time).
• days —last 7 samples, sampled every 24 hours (midnight to midnight
according to system time).
• weeks —last 12 samples, sampled every 7 days (midnight saturday to
midnight saturday according to system time).
• utilization —shows per time frame the utilization calculated.
• rx —shows received counters statistics.
To Next Page
Loading...
Need help?
General
