Cisco Sx350

Quality of Service (QoS) Commands
955 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
47
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
Use the default CoS value to assign a CoS value to all untagged packets entering
the interface.
Example
The following example defines the port
gi1 1 default CoS value as 3.
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# qos cos 3
47.32 qos dscp-mutation
Use the qos dscp-mutation Global Configuration mode command to apply the
DSCP Mutation map to system DSCP trusted ports. Use the no form of this
command to restore the trusted port with no DSCP mutation.
Syntax
qos dscp-mutation
no qos dscp-mutation
Parameters
N/A
Default Configuration
Disabled
Command Mode
Global Configuration mode
User Guidelines
Apply the DSCP-to-DSCP-mutation map to a port at the boundary of a Quality of
Service (QoS) administrative domain. If two QoS domains have different DSCP