Cisco Sx350

Address Table Commands
131 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
switchxxxxxx(config-if)# bridge multicast ip-address 239.2.2.2
The following example registers the IP address and adds ports statically.
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast ip-address 239.2.2.2 add gi14
4.6 bridge multicast forbidden ip-address
To forbid adding or removing a specific IP Multicast address to or from specific
ports, use the bridge multicast forbidden ip-address Interface (VLAN)
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
bridge multicast forbidden ip-address
{ip-multicast-address} {add | remove}
{ethernet
interface-list | port-channel port-channel-list }
no bridge multicast forbidden ip-address ip-multicast-address
Parameters
• ip-multicast-address—Specifies the group IP Multicast address.
• add—(Optional) Forbids adding ports to the group.
• remove—(Optional) Forbids removing ports from the group.
• ethernet interface-list —(Optional) Specifies a list of Ethernet ports.
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
• port-channel port-channel-list —(Optional) Specifies a list of port channels.
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.