Cisco Sx350

57
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1088
SPAN and RSPAN Commands
57.0
57.1 monitor session destination
To create a new Switched Port Analyzer (SPAN) or Remote SPAN (RSPAN)
destination session, use the monitor session destination command in Global
Configuration mode. To remove a destination session, use the no form of the
command.
Syntax
monitor session session_number destination {{interface interface-id [network]} |
{remote vlan
vlan-id reflector-port interface-id } network}
no monitor session
session_number destination
Parameters
•
session_number —Specify the session number identified with the SPAN,
RSPAN or flow mirror session. The range is 1 to 7.
• interface interface-id —Specify the destination interface for the SPAN,
RSPAN or flow mirror session (Ethernet port). When the source interface is a
RSPAN VLAN the RSPAN VLAN_ID is removed from all frames copied to the
interface.
• network—Specify that the destination port acts also as a network port.
• remote vlan vlan-id —Specify the RSPAN VLAN for an RSPAN destination
session. Not more than one RSPAN destination VLAN can be defined. The
VLAN must be defined as a RSPAN transit VLAN in the source, intermediate
and final switches by the remote-span command.
• reflector-port interface-id —Specify the destination interface for a RSPAN
session (Ethernet port). The RSPAN VLAN_ID is added to all frames copied
to the interface.