Cisco Sx350

ACL Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 72
2
switchxxxxxx(config-time-range)# absolute end 12:00 31 dec 2005
2.14 periodic
Use the periodic Time-range Configuration mode command to specify a recurring
(weekly) time range for functions that support the time-range feature. Use the no
form of this command to remove the time limitation.
Syntax
periodic
day-of-the-week hh:mm to day-of-the-week hh:mm
no periodic day-of-the-week hh:mm to day-of-the-week hh:mm
periodic list hh:mm to hh:mm day-of-the-week1 [day-of-the-week2…
day-of-the-week7]
no periodic list hh:mm to hh:mm day-of-the-week1 [day-of-the-week2…
day-of-the-week7]
periodic list hh:mm to hh:mm all
no periodic list hh:mm to hh:mm all
Parameters
• day-of-the-week—The starting day that the associated time range is in
effect. The second occurrence is the ending day the associated statement
is in effect. The second occurrence can be the following week (see
description in the User Guidelines). Possible values are: mon, tue, wed, thu,
fri, sat, and sun.
• hh:mm—The first occurrence of this argument is the starting hours:minutes
(military format) that the associated time range is in effect. The second
occurrence is the ending hours:minutes (military format) the associated
statement is in effect. The second occurrence can be at the following day
(see description in the User Guidelines). (Range: 0–23, mm: 0–59)
• list day-of-the-week1 —Specifies a list of days that the time range is in
effect.
Default Configuration
There is no periodic time when the time range is in effect.