EasyManuals Logo

Cisco Sx350 User Manual

Cisco Sx350
1323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #897 background imageLoading...
Page #897 background image
Power over Ethernet (PoE) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 896
45
45.7 power inline traps enable
To enable inline power traps, use the power inline traps enable Global
Configuration mode command. To disable traps, use the no form of this command.
Syntax
power inline traps enable
no power inline traps enable
Default Configuration
Inline power traps are disabled.
Command Mode
Global Configuration mode
Example
The following example enables inline power traps.
switchxxxxxx(config)#
power inline traps enable
45.8 power inline limit
To configure the power limit per port on an interface, use the power inline limit
Interface Configuration mode command. To return to default, use the no form of the
command.
Syntax
power inline limit
power
no power inline limit
Parameters
power—States the port power consumption limit in Milliwatts, Range is 0-60000.
Default Configuration
The default value is 30W

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Sx350 and is the answer not in the manual?

Cisco Sx350 Specifications

General IconGeneral
BrandCisco
ModelSx350
CategorySwitch
LanguageEnglish

Related product manuals