Cisco Sx350

35
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 755
Link Aggregation Control Protocol (LACP)
Commands
1
35.1 lacp port-priority
To set the physical port priority, use the lacp port-priority Interface (Ethernet)
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
lacp port-priority
value
no lacp port-priority
Parameters
value—Specifies the port priority. (Range: 1–65535)
Default Configuration
The default port priority is 1.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example sets the priority of
gi1 6.
switchxxxxxx(config)# interface gi16
switchxxxxxx(config-if)# lacp port-priority 247