Cisco Sx350

8
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 208
CDP Commands
8.0
8.1 cdp advertise-v2
To specify version 2 of transmitted CDP packets, use the cdp advertise-v2
command in Global Configuration mode. To specify version 1, use the no form of
this command.
Syntax
cdp advertise-v2
no cdp advertise-v2
Parameters
N/A
Default Configuration
Version 2.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# cdp run
switchxxxxxx(config)# cdp advertise-v2
8.2 cdp appliance-tlv enable
To enable sending of the Appliance TLV, use the cdp appliance-tlv enable
command in Global Configuration mode. To disable the sending of the Appliance
TLV, use the no form of this command.