Cisco Sx350

Web Server Commands
1317 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
69
69.2 ip http port
To specify the TCP port used by the web browser interface, use the ip http port
Global Configuration mode command. To restore the default configuration, use the
no form of this command.
Syntax
ip http port
port-number
no ip http port
Parameters
port
port-number —For use by the HTTP server. (Range: 1–65534)
Default Configuration
The default port number is 80.
Command Mode
Global Configuration mode
Example
The following example configures the http port number as 100.
switchxxxxxx(config)# ip http port 100
69.3 ip http server
To enable configuring and monitoring the device from a web browser, use the ip
http server Global Configuration mode command. To disable this function, use the
no form of this command.
Syntax
ip http server
no ip http server