Cisco Sx350 - Remote-Span

SPAN and RSPAN Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1094
57
switchxxxxxx(config)# monitor session 1 destination remote vlan 2 reflector-port
gi11
Example 3. The following example configures a final RSPAN session that copies
traffic from a RSPAN VLAN 2 to destination port
gi1 1:
switchxxxxxx(config)# vlan 2
switchxxxxxx(config-vlan)# remote-span
switchxxxxxx(config-vlan)# exit
switchxxxxxx(config)# monitor session 1 source remote vlan 2
switchxxxxxx(config)# monitor session 1 destination interface gi11
57.3 remote-span
To configure a virtual local area network (VLAN) as a RSPAN remote VLAN, use the
remote-span command in VLAN Configuration mode. To return to default, use the
no form of this command.
Syntax
remote-span
no remote-span
Parameters
This command has no arguments or keywords.
Default Configuration
A VLAN is not a RSPAN remote VLAN.
Command Mode
VLAN Configuration mode