Cisco Sx350

IGMP Proxy Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 480
22
Example
The following example prohibits forwarding from downstream interfaces:
switchxxxxxx(config)# ip igmp-proxy downstream protected
22.3 ip igmp-proxy downstream protected
interface
To disable or enable forwarding of IP Multicast traffic from a given downstream
interface, use the ip igmp-proxy downstream protected interface command in
Interface Configuration mode. To return to default, use the no form of this
command.
Syntax
ip igmp-proxy downstream protected interface {enabled | disabled}
no ip igmp-proxy downstream protected interface
Parameters
• enabled—Downstream interface protection on the interface is enabled.
IPv4 Multicast traffic arriving on the interface will not be forwarded.
• disabled—Downstream interface protection on the interface is disabled.
IPv4 Multicast traffic arriving on the interface will be forwarded.
Default Configuration
Global downstream protection configuration (see the ip igmp-proxy downstream
protected command)
Command Mode
Interface Configuration mode
User Guidelines
Use the ip igmp-proxy downstream protected interface disabled command to
block forwarding from the given downstream interface.
Use the ip igmp-proxy downstream protected interface enabled command to
allow forwarding from the given downstream interface.