Cisco Sx350

User Interface Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1238
66
Use the no banner login Line Configuration command to disable the Login banner
on a particular line or lines.
Example
The following example sets a Login banner that uses tokens. The percent sign (%)
is used as a delimiting character. Note that the $(token) syntax is replaced by the
corresponding configuration variable.
switchxxxxxx(config)# banner login %
Enter TEXT message. End with the character '%'.
You have entered $(hostname).$(domain)
%
When the login banner is executed, the user will see the following banner:
You have entered host123.ourdomain.com
66.3 configure
To enter the Global Configuration mode, use the configure Privileged EXEC mode
command.
Syntax
configure [
terminal ]
Parameters
terminal—(Optional) Enter the Global Configuration mode with or without the
keyword terminal.
Command Mode
Privileged EXEC mode
$(location) Displays the system location string.
$(mac-addre
ss)
Displays the base MAC address of the device.
Token Information displayed in the banner