Cisco Sx350

System Management Commands
1203 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
62
• Available - Power supply is connected but is not used.
• Not Connected - The PD port is not connected or not connected to PSE.
When the PD Power supply status is Active or Available the PD power supply type
can be one of the following:
• 802.3AF.
• 802.3AT.
• 60W POE.
When the power supply changes to PD power supply (PD), the following syslog
message is created: Power supply source changed to PD Power Supply.
Examples
switchxxxxxx> show system power-supply
Show power supported with PoE:
switchxxxxxx> show system power-supply
62.20 show system id
To display the system identity information, use the show system id EXEC mode
command.
Power Supply Status
Main Active
Redundant Available
Power Supply Status PoE Budget (Watt)
Main Active 70
Redundant Not Available
PD
gi18(AT) Available 0