Cisco Sx350

802.1X Commands
87 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
3
Example
The following example enables authentication based on 802.1x and the station’s
MAC address
on port gi1 1:
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# dot1x authentication 802.1x mac
3.7 dot1x guest-vlan
To define a guest VLAN, use the dot1x guest-vlan mode command in Interface
(VLAN) Configuration mode. To restore the default configuration, use the no form of
this command.
Syntax
dot1x guest-vlan
no dot1x guest-vlan
Parameters
N/A
Default Configuration
No VLAN is defined as a guest VLAN.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use the dot1x guest-vlan enable command to enable unauthorized users on an
interface to access the guest VLAN.
A device can have only one global guest VLAN.
The guest VLAN must be a static VLAN and it cannot be removed.
An unauthorized VLAN cannot be configured as guest VLAN.