Cisco Sx350

Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 390
17
Default Configuration
If capability is unspecified, defaults to list of all the capabilities of the port and
preferred slave mode.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example enables auto-negotiation on gi11.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# negotiation
17.9 flowcontrol
To configure the Flow Control on a given interface, use the flowcontrol Interface
(Ethernet, Port Channel) Configuration mode command. To disable Flow Control,
use the no form of this command.
Syntax
flowcontrol
{auto | on | off}
no flowcontrol
Parameters
• auto—Specifies auto-negotiation of Flow Control.
• on—Enables Flow Control.
• off—Disables Flow Control.
Default Configuration
Flow control is Disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode