Cisco Sx350

Address Table Commands
155 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
User Guidelines
The command may be used only when the interface in the regular (non-secure
with unlimited MAC learning) mode.
Use this command to change the default value before the port security command.
Example
The following example sets the port to limited learning mode:
switchxxxxxx(config)# interface gi14
switchxxxxxx(config-if)# port security mode max
switchxxxxxx(config-if)# port security max 20
switchxxxxxx(config-if)# port security
switchxxxxxx(config-if)# exit
4.25 show mac address-table
To display entries in the MAC address table, use the show mac address-table
Privileged EXEC mode command.
Syntax
show mac address-table [dynamic | static
| secure] [vlan vlan ] [interface
interface-id
] [address mac-address]
Parameters
• dynamic—(Optional) Displays only dynamic MAC address table entries.
• static—(Optional) Displays only static MAC address table entries.
• secure—(Optional) Displays only secure MAC address table entries.
• vlan—(Optional) Displays entries for a specific VLAN.
• interface interface-id —(Optional) Displays entries for a specific interface ID.
The interface ID can be one of the following types: Ethernet port or
port-channel.
• address mac-address —(Optional) Displays entries for a specific MAC
address.