Cisco Sx350

Radius Server Commands
991 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
49
Example
The following example displays radius server global configuration:
switchxxxxxx# show radius server configuration
Radius Server Status: Enabled
Authentication UDP port: 1812 (default)
Accounting UDP port: 1813 (default)
Authentication failure traps are enabled
Authentication success traps are enabled
Accounting traps are enabled
49.17 show radius server group
To display a Radius Server group configuration, use the show radius server group
command in Privileged EXEC mode.
Syntax
show radius server group [
group-name ]
Parameters
• group-name —Specifies a name of the group. (Length: 1–32 characters)
Command Mode
Privileged EXEC mode
User Guidelines
Use the show radius server group
group-name command, to display one group.
Use the show radius server group command, to display all groups.
Example
The following example displays radius server groups.
switchxxxxxx# show radius server group